The Nuts and Bolts of the Steel and Aluminum 232 Matters
- April 2, 2018
- Posted by: Kenneth J. Nunnenkamp | Giovanna M. Cinelli
- Category: Blog
On March 8, President Donald Trump announced that trade remedies would be imposed on steel and aluminum imports pursuant to Section 232 of the Trade Expansion Act of 1962.
Section 232 allows for trade remedies when the president, acting through and on the recommendation of the Department of Commerce, finds that imports threaten the national security of the United States. Upon such a finding, the president can “adjust the imports of an article and its derivatives” to remedy the situation.
Following the basic parameters recommended by the Commerce Department, the president ordered additional tariffs, which became effective on March 23, as follows:
For steel, an added tariff of 25% on imports from all countries, except those specifically excluded
For aluminum, an added tariff of 10% on imports from all countries, except those specifically excluded
Temporary country-based exclusions were granted for Canada, Mexico, the European Union, South Korea, Australia, Brazil, and Argentina
The temporary exclusions, which are aimed at allowing bilateral negotiations to occur, expire May 1, 2018
No quotas are included in the order, despite Commerce Department recommendations that tariff quotas be applied
The orders, along with the Annex and the guidance to US Customs and Border Protection, detail the Harmonized Tariff Schedule Codes to which the increased tariffs apply.
The tariffs apply to any covered products “entered, or withdrawn from warehouse for consumption, on or after 12:01 midnight March 23, 2018.” This means that the tariffs apply to products en route, or otherwise not “entered” (a term of art in US Customs law) by that date.
On March 19, the Commerce Department published exclusion request procedures in the Federal Register. Exclusion relief is available for
any steel article determined not to be produced in the United States in a sufficient and reasonably available amount or of a satisfactory quality; or
based upon specific national security considerations.
Only US parties may make exclusion requests. There is no deadline for exclusion requests, and any request will be published with 30 days allowed for responsive comments.
Excluded Countries—Temporary Reprieve Pending Negotiations
While excluded countries receive a temporary reprieve, the progress of negotiations will dictate whether the exclusions continue, and absent agreements that will provide relief to the US industry, the increased tariffs could become effective as of May 1, 2018 for excluded countries.
Copyright © 2018 by Morgan, Lewis & Bockius LLP. All Rights Reserved.